Bler

SCPI Commands :

ABORt:SIGNaling:MEASurement:BLER
STOP:SIGNaling:MEASurement:BLER
INITiate:SIGNaling:MEASurement:BLER

class BlerCls[source]

Bler commands group definition. 21 total commands, 8 Subgroups, 3 group commands

abort() → None[source]

# SCPI: ABORt:SIGNaling:MEASurement:BLER
driver.signaling.measurement.bler.abort()

Stops the measurement. The measurement enters the ‘RDY’ state.

abort_with_opc(opc_timeout_ms: int = -1) → None[source]

# SCPI: ABORt:SIGNaling:MEASurement:BLER
driver.signaling.measurement.bler.abort_with_opc()

Stops the measurement. The measurement enters the ‘RDY’ state.

Same as abort, but waits for the operation to complete before continuing further. Use the RsCMX_Signaling.utilities.opc_timeout_set() to set the timeout value.

param opc_timeout_ms:

Maximum time to wait in milliseconds, valid only for this call.

initiate() → None[source]

# SCPI: INITiate:SIGNaling:MEASurement:BLER
driver.signaling.measurement.bler.initiate()

Starts the measurement. The measurement enters the ‘RUN’ state.

initiate_with_opc(opc_timeout_ms: int = -1) → None[source]

# SCPI: INITiate:SIGNaling:MEASurement:BLER
driver.signaling.measurement.bler.initiate_with_opc()

Starts the measurement. The measurement enters the ‘RUN’ state.

Same as initiate, but waits for the operation to complete before continuing further. Use the RsCMX_Signaling.utilities.opc_timeout_set() to set the timeout value.

param opc_timeout_ms:

Maximum time to wait in milliseconds, valid only for this call.

stop() → None[source]

# SCPI: STOP:SIGNaling:MEASurement:BLER
driver.signaling.measurement.bler.stop()

No command help available

stop_with_opc(opc_timeout_ms: int = -1) → None[source]

# SCPI: STOP:SIGNaling:MEASurement:BLER
driver.signaling.measurement.bler.stop_with_opc()

No command help available

Same as stop, but waits for the operation to complete before continuing further. Use the RsCMX_Signaling.utilities.opc_timeout_set() to set the timeout value.

param opc_timeout_ms:

Maximum time to wait in milliseconds, valid only for this call.

Cloning the Group

# Create a clone of the original group, that exists independently
group2 = driver.signaling.measurement.bler.clone()

Subgroups